69
3 Remove the PCI riser assembly from the server. See “To remove the
PCI riser assembly” section on page 65.
4 While holding the blue release lever in (A), align the holes in the
PCI riser board with the retention pins on the riser assembly.
5 Slide the riser board toward the left (B), then release the blue
lever to lock the board in place.
6 Observe the post-installation instructions described on page 36.
Removing and installing a PCI card
To remove a PCI card:
1 Observe the ESD precautions and pre-installation instructions
described on page 35.
2 Remove the CPU air duct. Perform the instructions described in “To
remove the CPU air duct” section on page 42.
3 Remove the PCI riser assembly from the server. See “To remove the
PCI riser assembly” section on page 65.
4 Open the rear retention clip by pushing the blue slide upward (A)
and rotating clip to the fully open position.
5 When removing a full height PCI riser board, open the full length
PCI card retention clip on the front of the riser assembly by
rotating it 90 degrees outward (B).
To Next Page
Loading...
Need help?
General
