Chapter 10 179
Command Reference
:DISP:TEXT2:PAGE
10. Command Reference
:DISP:TEXT2:PAGE
Syntax :DISPlay[:WINDow]:TEXT2:PAGE <numeric>
:DISPlay[:WINDow]:TEXT2:PAGE?
Description Selects the page number of the instrument setup display area located on the right of the
display. The correspondence between the page number and the displayed item is as
follows:
Page
number
Description of displayed item
1 Measurement frequency and measurement signal level.
2 Averaging count and cable length.
3 Measurement range and Trigger delay time.
4 Voltage/current monitor value of the measurement signal.
5
Load standard definition method (Single/Multi) and the selected
channel number of the multi-compensation function.
6 Handler output (comparator result).
7 Lower and Upper limits of BIN1.
8 Lower and Upper limits of BIN2.
9 Lower and Upper limits of BIN3.
10 Lower and Upper limits of BIN4.
11 Lower and Upper limits of BIN5.
12 Lower and Upper limits of BIN6.
13 Lower and Upper limits of BIN7.
14 Lower and Upper limits of BIN8.
15 Lower and Upper limits of BIN9.
16 Lower and Upper limits of the secondary parameter.
17 Limit modes and reference values for BIN1 to BIN9.
18 On/off state of the AUX BIN function.
19 Count values of BIN1 and BIN2.
20 Count values of BIN3 and BIN4.
21 Count values of BIN5 and BIN6.
22 Count values of BIN7 and BIN8.
23 Count values of BIN9 and AUX BIN.
24 Count values of OUT OF BINS and OVLD.
To Next Page
Loading...
Need help?
General
