Using the Oscilloscope
To switch between the graphical interface and full-screen mode
3-30
To switch between the graphical interface and full-
screen mode
• To enable graphical interface mode, click on the outlined square wave
button in the upper right-hand corner of the display.
The button changes state, and the menus and measurement toolbar appear.
The graphical interface menus let you access all the functions in the
oscilloscope, including features that are not available from the front-panel
controls. You can also use the oscilloscope’s built-in information system.
• To enable full-screen mode, click the larger square wave button in the
upper right-hand corner of the display.
The button changes state, and the menus and measurement toolbar disappear.
Choosing this option allows you to focus only on the waveform and
measurement. You must make changes to the oscilloscope configuration using
the front panel.
Figure 3-20
Interface Mode Control Buttons
Use Knobs and Keys to Configure the Oscilloscope in Full-Screen Mode
In full-screen mode, the range of mouse pointer motion is limited to the area of the
button for enabling the interface. You must use the front-panel knobs and keys to
configure the oscilloscope.
Click this button
to enable full-
screen mode
Click this button
to enable
graphical
interface mode
To Next Page
Loading...
Need help?
General
