82
S:\Hp8960\Generic Documents\Manual Operation Getting Started Guide\Pi_manual operation getting started guide\chapters\cdma2000_gen_op_overview_man_measurements.fm
cdma2000 Measurement Procedures
Measuring Code Channel Time/Phase Error
These measurements can be made only when one of the following radio
configurations (see “How Do I Set Up a Call?” on page 52) is selected:
• (Fwd3, Rvs3)
• (Fwd4, Rvs3)
• (Fwd5, Rvs4)
1. Select the Code Channel Time/Phase Error measurement (see “B. Select
measurements.” on page 48). A typical display is shown below.
2. Set up the Time Limit and Phase Limit using the (
F3) and (F4) keys.
To Next Page
Loading...
Need help?
General
