226 Agilent InfiniiVision 2000 X-Series Oscilloscopes User's Guide
17 Save/Recall (Setups, Screens, Data)
To navigate storage locations
When saving or recalling files, the softkey in the second position of the
Save Menu or Recall Menu, along with the Entry knob, are used to
navigate to storage locations. The storage locations can be internal
oscilloscope storage locations (for setup files or mask files) or they can be
external storage locations on a connected USB storage device.
The softkey in the second position can have these labels:
• Press to go — when you can push the Entry knob to navigate to a new
folder or storage location.
• Location — when you have navigated to the current folder location (and
are not saving files).
• Save to — when you can save to the selected location.
• Load from — when you can recall from the selected file.
When saving files:
• The proposed file name is shown in the Save to file = line above the
softkeys.
• To overwrite an existing file, browse to that file and select it. To create
a new file name, see "To enter file names" on page 226.
To enter file names
To create new file names when saving files to a USB storage device:
1 In the Save Menu, press the File Name softkey.
You must have a USB storage device connected to the oscilloscope for
this softkey to be active.
2 In the File Name Menu, use the Spell, Enter, and Delete Character softkeys
to enter the file name:
• Spell — press this softkey and turn the Entry knob to select the
character at the current position.
• Enter — press this softkey to enter characters and move the cursor to
the next character position. Pushing the Entry knob is the same as
pressing the Enter softkey.
• Delete Character — press this softkey to delete the character at the
current position.
To Next Page
Loading...
Need help?
General
