OPERATION
Vecto r H® S eries ▪ Operat or’s M anual ▪ M N-46 2 95 ▪ Rev 7 ▪ 6/22
79
Continued from previous page
4. Scroll to System Backup & Update.
Touch the Update system software d setting.
Touch Control Board (CB) to update the control board. The oven loads the
selected software. The oven verifies the file and then updates the CB.
Touch Front End to update the user interface software. The oven loads the
selected software.
Touch Back End to update the supporting software between the control
board (CB) and interface board (IB). The oven loads the selected software.
5. Touch the check mark when the update is complete to restart the oven.
6. Remove the USB drive.
Result The software has now been updated.
NOTICE
Do not remove the USB drive during the update
process.
To Next Page
Loading...
Need help?
General
