APRILIA ATLANTIC 500 User Manual

46
use and maintenance Atlantic 500
1
2
WARNING
WARNING
◆ Unscrew and extract the plug/dipstick (1).
◆ Clean the part in contact with the oil with
a clean cloth.
◆ Tighten the plug/dipstick (1) fully into the
filler hole.
◆ Extract the plug/dipstick (1) again and
check oil level on the dipstick:
MAX = maximum level;
MIN = minimum level.
◆ Correct level is achieved when the oil
reaches or is just below the dipstick MAX
level mark.
Oil level must be between the MAX and
MIN level mark. Incorrect oil level will
cause severe engine damage.
◆ Top up if needed.
TOPPING UP
◆ Pour a small quantity of oil into the filler
opening. Allow one minute for oil to flow
into the crankcase.
◆ Check level and top up if needed.
◆ Top up with small quantities of oil until
obtaining the correct level.
◆ When finished, tighten the plug/dipstick (1).
USE SAE 80W/90 OIL EXCEEDING THE API
GL3 SPECIFICATION.
Do not use the vehicle when lubricant levels
are low or lubricant has become
contaminated. Use specified lubricants only.
Improper lubrication will lead to working
parts fretting, resulting in irreparable
damage.
WARNING
CHANGING TRANSMISSION OIL
Read page 26 (LUBRICANTS), page 40
(MAINTENANCE) and page 74 (LUBRICANT
CHART).
NOTE Place the vehicle on firm and level
ground.
◆ Place the vehicle on the centre stand.
The engine and exhaust system components
stay hot for some time even after the engine
has been stopped. Wear heat gloves before
handling these components or allow for the
engine and the exhaust system to cool down.
◆ Stop the engine and let it cool down. This
will allow the oil to settle into the oil pan
and cool down.
NOTE Accurate oil level measurement is
only ensured when the above procedures
are observed.

APRILIA ATLANTIC 500 Specifications

General

Brand	APRILIA
Model	ATLANTIC 500
Category	Scooter
Language	English