6
7
8
9
10
◆ Slightly move the front cover wings apart,
as shown by arrows “A” so as to release
the meshing tabs from front fairing.
◆ Slightly raise cover lower part, as shown
by arrow “B”.
◆ Pull the front cover (5) gently to remove.
Ensure that the tabs with the clips locate
correctly into their seats on refitting.
THROTTLE TWISTGRIP ADJUSTMENT
Read page 40 (MAINTENANCE) carefully.
There should be 2–3 mm free play in the
throttle twistgrip cable (measured at twistgrip
edge).
If not so:
◆ Place the motorcycle on the centre stand.
◆ Take off the rubber gaiter (6).
◆ Loosen the locknut (7).
◆ Rotate the adjuster (8) until setting the
specified free play.
◆ After adjusting, tighten the locknut (7) and
check free play again.
◆ Refit the rubber gaiter (6).
◆ Cable (9) opens the throttle.
◆ Cable (10) closes the throttle.
Turn the handlebar and ensure that idling
speed is unaffected by handlebar
movement. Open the throttle and ensure
that the twistgrip springs back to the closed
position smoothly and gradually when
released.
WARNING
CAUTION
To Next Page
Loading...
Need help?
General