76
BULBS
Before changing a bulb, turn the ignition
switch to position "
m".
Change the bulb wearing clean gloves.
Do not leave fingerprints on the bulb,
since these may cause its overheating
and consequent breakage.
If you touch the bulb with bare hands, remove
any fingerprint with alcohol, in order to prevent it
from blowing frequently.
Read page 50 carefully.
CHANGING THE HEADLIGHT BULBS
(Fig. 55-56)
To change the low and high beam bulbs, proceed
as follows:
– take off the rubber cup (1-Fig. 55);
– take off the connector;
– act on the "V"-spring and extract the socket with
the bulb;
– replace the damaged bulb;
– to reassembly, carry out the same operations re-
versing the order.
To change the parking light bulb, proceed as fol-
lows:
– remove the rubber socket (1-Fig. 56) and extract
the bulb;
– if it is damaged, replace the bulb.
Fig. 55
Fig. 56
a
To Next Page
Loading...
Need help?
General
