GENERAL TECHNICAL INFORMATION
2-21
SCARABEO 500
2.2.3. COOLANT
CHECKING AND TOPPING UP
WARNING
Wait for the engine to cool down before
checking or topping up coolant level.
• Stop the engine and wait until it has cooled down.
NOTE Position the vehicle on firm and flat ground.
• Remove the front cover, see (REMOVING THE
FRONT COVER).
• Ensure that fluid level inside expansion tank (2) is
between “MIN” and “MAX” notches.
MIN = minimum level.
MAX = maximum level.
If not so:
• Loosen the filler plug (1) (by turning it anticlockwise),
without removing it.
• Wait a few seconds in order to release any residual
pressure.
• Unscrew and remove the plug (1).
WARNING
Do not add additives or other substances to the
fluid.
• Top up with coolant, see (LUBRICANT CHART), until
level reaches approximately “MAX” mark.
• Level should not exceed this mark, or fluid will leak out
during engine operation.
• Put back the filling cap (1).
WARNING
If coolant level drops too quickly or the
expansion tank is empty, check the cooling
circuit for leaks.
To Next Page
Loading...
Need help?
General