Scheduled maintenance table
CAUTION
FIRE HAZARD.
FUEL OR ANY OTHER INFLAMMABLE SUBSTANCES MUST NOT BE CLOSE TO
ELECTRICAL COMPONENTS.
BEFORE ANY MAINTENANCE OPERATION OR INSPECTION ON THE MOTOR-
CYCLE, SHUT OFF THE ENGINE AND REMOVE THE KEY. WAIT UNTIL THE
ENGINE AND THE EXHAUST SYSTEM ARE COLD, IF POSSIBLE LIFT THE
SCOOTER WITH A SPECIFIC TOOL ON A FIRM AND LEVEL GROUND.
BEFORE ANY OPERATION, MAKE SURE THAT THE ROOM WHERE YOU ARE
HAS ADEQUATE AIR VENTILATION.
TO AVOID BURNS BE SPECIALLY CAREFUL WITH HOT ENGINE AND EXHAUST
SYSTEM PARTS.
DO NOT HOLD ANY MECHANICAL OR OTHER MOTORCYCLE PARTS WITH
YOUR MOUTH: MOTORCYCLE COMPONENT ARE NOT EDIBLE, ON THE CON-
TRARY SOME OF THEM ARE HARMFUL AND EVEN TOXIC.
NOTE
UNLESS OTHERWISE INDICATED, REFIT THE UNITS FOLLOWING THE RE-
MOVAL STEPS BUT IN REVERSE ORDER.
WHEN CARRYING OUT MAINTENANCE OPERATIONS, IT IS ADVISABLE TO
WEAR LATEX GLOVES.
In general terms, routine maintenance operations can be carried out by the owner; in
some cases it is necessary to use specific tools and have some technical knowledge.
106
To Next Page
Loading...
Need help?
General
