Aqua Computer D5 NEXT User Manual

D5 NEXT
to a vertical surface. If these mounting options are not used, the silicone damper
of the pump can be replaced with a flat silicone insert.
Please note that all mounting options that make use of the silicone damper require
the pump to be installed vertically above the damper and are not designed to
withstand lateral stress or transportation of the PC!
4.2.
4.2.4.2.
4.2. Installation to a top/cover or reservoir
Installation to a top/cover or reservoirInstallation to a top/cover or reservoir
Installation to a top/cover or reservoir
For operation of the pump, a compatible top/cover is required, alternatively the
pump may be installed directly to a compatible reservoir. In both cases, the pump
motor will be held in place by fixation rings to be slid over the pump. In order to
do so, detach the controller unit from the pump motor unit, fasten the pump motor
using the fixation ring and re-attach the controller unit.
4.3.
4.3.4.3.
4.3. Permitted pump orientations
Permitted pump orientationsPermitted pump orientations
Permitted pump orientations
During operation, the impeller of the pump must be directed upwards or to the
side relative to the controller unit. Operation with downwards oriented, “hanging”
impeller is not permitted!
5.
5.5.
5. Electrical connections
Electrical connectionsElectrical connections
Electrical connections
ATTENTION: Completely turn off your power supply or disconnect the mains pow-
er cord from the wall outlet before connecting or disconnecting any cables to/from
the device!
5.1.
5.1.5.1.
5.1. Power Connector
Power ConnectorPower Connector
Power Connector
Connect a SATA power plug of your PC's power supply unit to this connector. Do
not use excessive force but double check the polarity of the plug if you are having
trouble to connect.
Pin assignment: Pin 1, 2, 3, 11: not connected
Pin 4, 5, 6, 10, 12: GND
Pin 7, 8, 9: 5 V DC
Pin 13, 14, 15: 12 V DC
5.2.
5.2.5.2.
5.2. Connector “USB”
Connector “USB”Connector “USB”
Connector “USB”
This connector is used for USB communication with a PC. Connect to an internal
USB header of your motherboard. Take special care to make sure the pin align-
ment matches your motherboard! The USB interface is used for data exchange
with the PC and not required for pump operation.
The corresponding connector on the motherboard is usually
a 9 pin connector with two independent USB ports. Both
rows of 4/5 pins can be used to connect an USB device.
- 6 - Aqua Computer GmbH & Co. KG © 2019-2020
Gelliehäuser Str. 1, 37130 Gleichen
c
o
m
p
u
t
e
r
a
q
u
a

Aqua Computer D5 NEXT Specifications

General

Brand	Aqua Computer
Model	D5 NEXT
Category	Water Pump
Language	English