Atlas Copco CC 1700 U User Manual

♦
Transport the hydraulic demolition cutter with the
cutter jaws open.
There is less oil in the hydraulic demolition cutter if
the hydraulic demolition cutter is transported with
open cutter jaws. In the event of a leak, less oil is
lost and the environmental damage is lower.
♦
Open the hydraulic demolition cutter before
transporting it.
♦
If the hydraulic demolition cutter is transported
using a crane, secure the cutter jaws with a square
timber to keep them open.
♦
If the hydraulic demolition cutter is transported
with a forklift truck or lorry, secure the cutter jaws
to the pallet with suitable strapping to keep them
open.
Transport using a crane
♦
Secure the hydraulic attachment with ropes or
chains as shown in the following illustration.
♦
Slowly lift the hydraulic attachment.
♦
Place the hydraulic attachment on a pallet.
Transport using a forklift truck
WARNING Hydraulic attachment tipping over
The hydraulic attachment tipping off the fork of the
forklift truck or the pallet may cause serious injury.
► Place the hydraulic attachment on a pallet.
► Strap the hydraulic attachment to the pallet using
suitable strapping, as shown in the illustration
below.
► Move the fork of the forklift truck under the pallet
so that the centre of gravity is between the prongs.
♦
Move the fork of the forklift truck under the pallet
so that the hydraulic attachment cannot tip over.
♦
Slowly lift the pallet with the hydraulic attachment.
♦
Transport the pallet with the hydraulic attachment
to the location provided for.
© 2015 Construction Tools GmbH | No. 3390 5141 01 | 2015-11-16
Original instructions
20
CC 1700 U, 1700 STRANSPORT

Atlas Copco CC 1700 U Specifications

General

Brand	Atlas Copco
Model	CC 1700 U
Category	Industrial Equipment
Language	English