STORAGE
Hydraulic demolition cutter
WARNING Falling hydraulic demolition cutter
The hydraulic demolition cutter is heavy. If it topples
over where it is stored, it may cause injury.
► Store the hydraulic demolition cutter horizontal on
squared timbers or a pallet on a horizontal base.
The following procedure applies to storage:
♦
Open the cutter jaws.
There is less oil in the hydraulic demolition cutter if
the cutter jaws are open. In the event of a leak, less
oil is lost and the environmental damage is lower.
♦
Remove the hydraulic demolition cutter from the
carrier (see chapter Removing the hydraulic
attachment from the carrier).
♦
Store the hydraulic demolition cutter in a dry,
well-ventilated room.
♦
If storage is only possible outdoors, then the
hydraulic demolition cutter is to be protected from
the weather with plastic film or tarpaulins.
♦
Store the hydraulic demolition cutter horizontal on
squared timbers or a pallet on a horizontal base.
Cutter jaws removed
WARNING Removed cutter jaws falling
The cutter jaw pair is heavy. If it topples over where
it is stored, it may cause injury.
► Secure the cutter jaw pair on the assembly rack
to prevent it falling over.
The following procedure applies to storage:
♦
Store the cutter jaw pair in a dry, properly
ventilated room.
♦
If you can only store the cutter jaw pair in the open
air, protect it against the weather with plastic film
or tarpaulins.
♦
Store the cutter jaw pair secured on the assembly
rack on a horizontal base.
Grease cartridges
WARNING Fire and harmful vapors
Cutter grease can burn and cause serious fire.
Harmful vapors are generated when cutter grease
is burnt.
► Never store grease cartridges near
fire-propagating or self-igniting substances.
► Do not expose the grease cartridges to direct
sunlight.
♦
Store the grease cartridges in a cool, properly
ventilated room.
61© 2015 Construction Tools GmbH | No. 3390 5141 01 | 2015-11-16
Original instructions
STORAGECC 1700 U, 1700 S
To Next Page
Loading...
Need help?
General
