4 Installation
4.1 Installation proposal
Outdoor/altitude operation
If the compressor is installed outdoors or if the ambient temperature can be below 0˚C (32˚F),
precautions must be taken. In this case, and also if operating at high altitude, consult Atlas
Copco.
Moving/lifting
Transport by a pallet truck
To prevent a tank-mounted model from falling over during transport by a pallet truck:
push the forks underneath the air receiver and place a wooden beam (1) (cross-section
approx. 4 x 6 cm / 1.6 x 2.4 in) through the supports on both sides of the receiver. While
holding the compressor, slowly lift the forks until the receiver is secured between the
beams. Move the compressor gently.
Instruction book
2920 7199 10 47
To Next Page
Loading...
Need help?
General
