28 29
Torque Compensation
By using torque compensation, the actual clamping force applied to the joint
can be better determined and the scatter in the applied clamping force can
be reduced.
The torque compensation point is set by using a previously specified angle
from Rundown complete and then calculating a value for the torque used
during rundown. When creating the preload in the bolt, this is compensated
for by adding the torque value calculated in the torque compensation point,
to the Target torque.
Stop Stage
The Stop stage terminates the tightening so that the socket can be released.
Soft Stop
Soft stop makes the tightening stop in a more ergonomic fashion. Avoiding
the tool to stop within the time interval of 50-300 ms, since it is known to
create an uncomfortable stop.
Parameter Description Default Value
Torque compensation Enables adjusting Target torque for torque used in the
rundown stage.
Off: No compensation made.
On: Manually sets the Torque compensation point.
Off
Parameter Description Default Value
Soft stop Turns the soft stop on or off.
Off: No soft stop is used.
On: Soft stop is activated. When target torque is reached the
tool speed is immediately decreased to 75%. Then the speed
is decreased to zero in at most 40 ms.
Off
To Next Page
Loading...
Need help?
General
