EasyManuals Logo
Home>AudioCodes>Gateway>MediaPack MP-11 Series

AudioCodes MediaPack MP-11 Series Hardware Installation Manual

AudioCodes MediaPack MP-11 Series
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
CHAPTER3 Physical Description
Mediant 1000 Gateway & E-SBC | Hardware Installation Manual
Table 3-3: FXS Module LED Description
Color State Description
Green On Phone connected to the port is off-hooked.
Blinking Phone connected to the port rings.
Red On Error - malfunction in line or out of service due to Serial Peripheral
Interface (SPI) failure.
FXO Module
The FXO module provides the Foreign eXchange Office (FXO) interfaces. Up to six FXO modules
can be installed in the device. Each FXO module can provide up to four FXO interfaces and
therefore, the device can support up to 24 FXO interfaces (i.e., 6 modules x 4 ports).
The standard FXO module supports outdoor and indoor (lightning protection)
loop-start signaling. The FXO G module supports both loop- and ground-start
signaling (but only supports indoor protection).
To enable ground-start signaling, use the [GroundKeyDetection] parameter (refer
to the device's User's Manual).
Ports Description
Each FXO module provides up to four analog RJ-11 ports. The ports are labeled I, II, III, and IIII.
Figure 3-3: FXO Module
LED Description
Each FXO port provides a LED indicating operating status, as described in the following table:
- 6 -

Table of Contents

Other manuals for AudioCodes MediaPack MP-11 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AudioCodes MediaPack MP-11 Series and is the answer not in the manual?

AudioCodes MediaPack MP-11 Series Specifications

General IconGeneral
BrandAudioCodes
ModelMediaPack MP-11 Series
CategoryGateway
LanguageEnglish

Related product manuals