To Next Page

To Previous Page

Installation Manual 42 Document #: LTRT-59811

MediaPack Series

3.2 Configuring Basic SIP Parameters

Once you have completed the previous sections, you are ready to start configuring the

device using the Web interface. For information on how to fully configure the device, refer to

the device's User’s Manuals.

Tip:

Once the device is configured, backup your settings by saving the

configuration (ini) file to your PC. This saved file can later be used, if

necessary, to restore configuration settings (refer to 'Backing Up and

Restoring Configuration' on page 47).

¾ To configure basic SIP parameters:

1. Access the Web interface.

2. Select the voice coders used by the device that best suits your VoIP network in the

'Coders Table' page (Configuration tab > Protocol Configuration menu > Coders

And Protocol Definitions submenu > Coders).

3. When operating with a Proxy server, perform the following (otherwise, skip to Step 4):

a. In the 'Proxy & Registration' page (Configuration tab > Protocol Configuration

menu > Proxies, Registration, IP Groups submenu > Proxy & Registration):

♦ Set the ‘Use Default Proxy’ field to "Yes".

♦ (Optional) In the ‘Proxy Name’ field, enter the Proxy's name. The Proxy

name replaces the Proxy IP address in all SIP messages. This means that

messages are still sent to the physical Proxy IP address, but the SIP URI

contains the Proxy name instead.

♦ To enable the device to register to a Proxy/Registrar server (at power up and

every user-defined interval - ‘Registration Time’ parameter), set the ‘Enable

Registration’ parameter to "Enable".

b. In the 'Proxy Sets Table' page (Configuration tab > Protocol Configuration

menu > Proxies, Registration, IP Groups submenu > Proxy Sets Table), define

the IP address(s) of the Proxy server(s). When no Proxy is used, the internal

routing table is used to route the calls.

4. Enable the device's endpoints in the 'Endpoint Phone Number Table' page

(Configuration tab > Protocol Configuration menu > Endpoint Number submenu >

Endpoint Phone Number).

5. If a Proxy server is not implemented, map outgoing calls to IP addresses in the

‘Outbound IP Routing Table’ page (Configuration tab > Protocol Configuration

menu > Routing Tables submenu > Tel to IP Routing).

6. Save your settings to the flash memory and reset the device (refer to 'Saving and

Resetting the Device' on page 44).

AudioCodes MediaPack User Manual

Questions and Answers: