3
Safety instructions
Safety stickers
Safety instructions
B
• Do not place hands or objects in dril-
ling area during drilling and insertion.
• Do not remove protective shields
- danger of injury!
Safety instructions
• This drilling head has been designed
for use with PRO-CENTER 2000 and
must only be attached to this machine.
This drilling head has been designed
for System 32 and for drilling dowel
holes in work pieces of wood, press-
board or plastic laminated wood.
The manufacturer is not liable for any
other applications!
• Familiarise yourself with the opera-
tion of PRO-CENTER 2000 before
working with drilling head MZK.2880.
Read the operating instructions of
PRO-CENTER 2000 first.
• Set operating mode switch (E2) to
position before changing tools, re-
setting or when working in the drilling
area.
• Only use sharp, clean drill bits when
working!
• Particular care must be taken when
working on work pieces which jut out
over the worktable.
• Secure the work piece during work!
Use the machine's hold-down clamps
to do so. If these are insufficient, find
a suitable fastening device.
• Make sure that all safety devices
function properly before starting
operation. Replace defective parts
with genuine spare ones.
• Make sure that no other tools or
objects are on the worktable aside
from your work piece before turning
on the machine!
• For your own safety, use only the
accessories recommended or stated
in the operating instructions or in
Blum's catalogue.
• Noise emissions
Emission standard at work place
To Next Page
Loading...
General