BPAP Series User Manual V1.0
21 / 58
11.8 Starting Treatment
Connect the device to a power outlet, press the Start / Stop Button and the
device will start delivering air.
WARNINGS!
• Be sure to follow your physician’s instructions on adjusting the settings! To order any
accessories not included with this device, contact your equipment supplier.
• DO NOT connect any ancillary equipment to this device unless recommended by BMC or
your physician. If you suffer from chest discomfort, shortness of breath, stomach bloating, or
severe headache when using the device, contract your physician or qualified medical
personnel immediately.
12. Routine Use
12.1 Connecting the Tubing
Connect the power cord, power adapter, and tubing properly according to the instructions in
the First Time Setup (Chapter 11). Connect the mask and headgear according to the user
manual for the mask.
CAUTION!
• Before each use, examine the tubing for any damage or debris. If necessary, clean the
tubing to remove the debris. Replace any damaged tubing. Make sure that the mask does
not leak.
12.2 Adjusting the Tubing
Lie down on your bed, and adjust the tubing so it is free to move if you turn during sleep.
Adjust the mask and headgear until you have a comfortable fit and until there are no airflow
leaks around the mask.
12.3 Turning on the Airflow
Press the Start / Stop Button to turn on the airflow. The screen will display
treatment pressure and other information.
12.4 Heating the Water
Pay attention to the number next to the icon when using the humidifier. The number
indicate the On / Off state of the humidifier. It is off when the number next to the icon is 0.
CAUTION!
• Observe the water level of the water chamber before using the humidifier. Make sure there
is sufficient water in the water chamber, and avoid heating the device with an empty water
chamber.
To Next Page
Loading...
Need help?
General
