BPAP Series User Manual V1.0
26 / 58
Fig. 13-8
WARNING!
• Do not touch the heater plate of the device when it is working, otherwise you may get
burned. Turn off the heat when the heated humidifier is not in use.
CAUTIONS!
• Generally speaking, the humidity inside the mask is low when the water temperature is low.
• The greater the difference between the temperature inside the air tubing and room
temperature is, the more easily condensation occurs inside the tubing.
• If there are only a few condensed water droplets inside the tubing in the morning after
therapy, it means that the humidity level is appropriate; if there is lots of condensed water
droplets inside the tubing and / or mask, it means that the humidity level is too high and
should be set lower; Nasal dryness means that the humidity level is too low and should be set
higher.
14. Using the SpO
2
Kit
Connect the SpO
2
Kit to the device according to the user manual for the SpO
2
Kit. After the
device is powered on, start the device, the screen of the device then displays the Main
Interface shown in Fig. 14-1. The patient's blood oxygen saturation and pulse rate can be
clearly seen during the course of therapy.
Fig. 14-1
For more details, please refer to the SpO
2
Kit user manual.
To Next Page
Loading...
Need help?
General
