G2S BPAP Series User Manual V2.1
14 / 43
(2) Install the filter cap containing the air filter to the device, as shown in Fig. 11-2.
Fig. 11-2
CAUTIONS!
• The air filter must be in place when the device is operating.
• Installing the air filter and filter cap, device must be unplugged.
11.3 Connecting to Power
(1) Insert the plug of the power adapter into the DC Inlet on the back of the device;
(2) Connect the power cord to the power adapter;
(3) Plug the other end of the power cord into the power outlet.
Fig. 11-3
Note: The length of the power cord and power adapter is 1.5 m and 1.8 m respectively
without the function of preventing electromagnetic interference.
WARNINGS!
• The device is powered on for use when the power cord and power adapter is connected.
The Knob turns the blower On / Off.
• Use of the device at an AC voltage beyond the stated range (see Section 5 “AC Power
Consumption”) may damage the device or cause device failure.
• Connect to appropriate power for proper operation of the device.
CAUTION!
• Inspect the power cord often for any signs of damage. Replace a damaged cord immediately.
To Next Page
Loading...
Need help?
General
