To Next Page

To Previous Page

- Maintain the brake arms against the stoppers, apply tension on the cable and clamp the cable (1). Once the cable is tight, check the

function of the brake lever. There should not be play in the lever and the brake arms should come back all the way to the

stoppers. Repeat operation if needed.

Cable tension (rear brake)

- Cut the cable 40mm away from the brake arm (1), then clip the cable back into the down tube (3).

To mount various rim dimensions, and also to compensate pad wear, the reach of the brake pads needs to be adjusted with spacers.

Please refer to your wheels manufacturers instructions regarding which brake pad compound you should use.

Brake pads setting

Exemple: Pads fully in and fully out:

Building a timemachine

Questions and Answers:

Need help?

Do you have a question about the BMC TMR01 and is the answer not in the manual?

BMC TMR01 Specifications

General