Mobility
233
Reference OverviewControlsDriving hintsCommunication NavigationEntertainment
After fitting
1. Tighten the studs alternately on opposite
sides of the hub.
For safety reasons, have the wheel
stud tightening torque checked with-
out delay, using a calibrated torque wrench.
The correct tightening torque is 140 Nm,
approx. 103 lb ft.<
2. Proceed in the reverse sequence when
storing the wheel and tools.
3. Correct the tyre pressure at the earliest
opportunity.
Prevent dirt from entering the tyre
valves by attaching screw-on dust
caps. Dirt in the tyre valve can often lead to
a gradual loss of air pressure.<
4. Reinitialise the Run Flat Indicator, see
page 87.
5. Replace the damaged tyre as soon as pos-
sible and have the new wheel balanced.
Driving with the spare wheel
With certain wheel/tyre combinations, the
size of the spare wheel differs from that of
the other wheels. The spare wheel is suitable
without restriction for driving at all loads and
speeds. However, you are advised to fit a wheel/
tyre combination that matches the original
specification as soon as possible.<
Thiefproof wheel studs
1 Wheel stud for adapter
2 Adapter, beneath the luggage compart-
ment floor next to the wheel stud wrench
Removing a wheel stud
1. Insert adapter 2 in the wheel stud.
2. Unscrew wheel stud 1 with the wheel stud
wrench.
After screwing in, remove the adapter again and
stow it away in its designated location.
The code number is embossed on the face of
the adapter. Please note this number and keep
the details in a safe place in the event of the
adapter being lost.
Car battery
Maintenance
The battery needs no routine maintenance
whatsoever, in other words the quantity of acid
it contains will normally last for the full operating
life of the battery in temperate climates. BMW
Service will gladly advise you on all matters
relating to batteries.
Recharging the battery
Recharge the battery only with the engine
stopped, via the connections in the engine
compartment. Connections, see Starting with a
flat battery on page 236.
Battery switch
If the car is to remain out of use for several
weeks, push the battery switch behind the
right-hand side trim in the luggage compart-
ment to the OFF position. This reduces current
consumption while the car is out of use. A mes-
sage appears on the info display. Observe the
supplementary information on the control dis-
play.
Online Edition for Part no. 01 41 0 013 197 - © 02/07 BMW AG
To Next Page
Loading...
Need help?
General
