minimum tread depth is
reached.
Make sure ground is level and
firm and park motorcycle.
Measure tire tread depth in
main tread grooves with wear
indicators.
NOTICE
Tread wear marks are integrated
into the main grooves on every
tire. If the tire tread has worn
down to the level of the marks,
the tire is completely worn. The
locations of the marks are indi-
cated on the edge of the tire, e.g.
by the letters TI, TWI or by an
arrow.
When the minimum tread depth
is reached:
Replace the worn tires.
Chain
Lubricating chain
ATTENTION
Insufficient cleaning and lu-
brication of the drive chain.
Increased wear.
Clean and lubricate the drive
chain regularly.
Lubricate drive chain at least
every 620 mls (1000 km). After
driving though water or dust
and dirt perform the lubrication
at shorter intervals.
Switch off ignition and engage
Neutral.
Clean drive chain with suitable
cleaning agent, dry and apply
chain lubricant.
Wipe off excess lubricant.
Check chain sag
Make sure ground is level and
firm and park motorcycle.
Turn the rear wheel until the
position with the lowest chain
sag is reached.
Press chain upward and down-
ward using a screwdriver and
measure difference A.
Chain sag
1.4...1.8 in (35...45 mm) (Mo-
torcycle unloaded on side
stand)
8
103
z
Maintenance
ProCarManuals.com
To Next Page
Loading...
Need help?
General
