In this case, the receiver on the
motorcycle no longer reacts to
the signals of the remote control.
Synchronize remote
control
Press and hold button 1 and
button 2.
LED flashes for ten seconds.
As soon as the LED goes out,
release button 1 and button 2.
LED lights up.
Press button 1 or button 2.
LED goes out.
Remote control is synchro-
nized.
Battery
with anti-theft alarm system
(DWA)
OE
When is a battery change
required?
The batteries of the remote con-
trol must be replaced after ap-
prox. 2-3 years. A weak battery
can be recognized from the fact
that the LED does not light up at
all or only briefly when a button is
pressed.
Replace battery
Remove screw 1 and take off
lower housing section 2.
Slide old battery 3 forward un-
der bow 4.
ATTENTION
Unsuitable of improperly in-
serted batteries.
Component damage
Use specified battery (see
"Technical Data" chapter).
When inserting the battery,
make sure that the polarity is
correct.
5
69
z
Anti-theft alarm system DWA
ProCarManuals.com
To Next Page
Loading...
Need help?
General
