10 The reserve fuses are
connected in the fuse
box and suspended from
the cable for the dia-
gnostic connector.
Front-wheel stand
Installing the front-wheel
stand
ATTENTION
Use of the BMW Motorrad
front wheel stand without ac-
companying use of centre
stand or auxiliary stand
Risk of damage to parts if vehicle
topples
Place the motorcycle on its
centre stand or another auxili-
ary stand before lifting the front
wheel with the BMW Motorrad
front-wheel stand.
with centre stand
OA
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
without centre stand
OA
Place the motorcycle
on an auxiliary stand;
BMW Motorrad recommends
the BMW Motorrad auxiliary
stand.
Install the rear-wheel stand
( 70).
Use basic stand with front-
wheel adapter.
The basic stand and its ac-
cessory parts are available from
your BMW Motorrad dealer.
Slacken clamping screws 1.
Push the two adapters 2 apart
until the front forks fit between
them.
Use locating pins 3 to set the
front-wheel stand to the de-
sired height.
Centre the front-wheel stand
relative to the front wheel and
push it against the front axle.
8
69
z
Maintenance
To Next Page
Loading...
Need help?
General
