Align the two adapters 2 so
that the front forks are securely
seated.
Tighten clamping screws 1.
ATTENTION
Centre stand retracts if mo-
torcycle is lifted too high
Risk of damage to parts if vehicle
topples
When raising the vehicle, make
sure that the centre stand re-
mains on the ground.
Apply uniform pressure to push
the front-wheel stand down
and raise the motorcycle.
Rear-wheel stand
Install the rear-wheel
stand
Set the height of the stand 3
so that it raises the rear wheel
slightly off the ground.
Ensure that the stand height is
the same on the left and right,
and secure the mount 3 on
either side with bolts 1.
Set the mounts 3 to the width
of the rear wheel swinging
arm 4 and secure using clamp-
ing bolts 2.
Ensure you do not cover the
axle 5.
8
70
z
Maintenance
To Next Page
Loading...
Need help?
General
