BMW G 310 GS User Manual

WARNING
Brake-pad thickness less
than permissible minimum
Diminished braking effect, dam-
age to the brakes
In order to ensure the depend-
ability of the brake system, do
not permit the brake pads to
wear past the minimum per-
missible thickness.
Have the brake pads replaced
by a specialist workshop,
preferably an authorised
BMW Motorrad dealer.
BMW Motorrad recommends
you only install genuine brake
pads from BMW Motorrad.
Check rear brake pad
thickness
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
WARNING
Brake-pad thickness less
than permissible minimum
Diminished braking effect, dam-
age to the brakes
In order to ensure the depend-
ability of the brake system, do
not permit the brake pads to
wear past the minimum per-
missible thickness.
Visually inspect the brake pads
to ascertain their thickness.
Viewing direction: from the rear
toward brake pads 1.
Inspect the chamfer 2.
Brake-pad wear limit,
rear
min 1.0 mm (Friction lining
without carrier plate)
If the chamfer is no longer visible:
Have the brake pads replaced
by a specialist workshop,
preferably an authorised
BMW Motorrad dealer.
8
74
z Maintenance

BMW G 310 GS Specifications

General

Displacement	313 cc
Bore x Stroke	80 mm x 62.1 mm
Maximum Torque	28 Nm at 7, 500 rpm
Transmission	6-speed
Fuel System	Electronic fuel injection
Front Suspension	Upside-down fork, Ø 41 mm
ABS	BMW Motorrad ABS
Seat Height	835 mm
Wheelbase	1, 420 mm
Engine Type	Water-cooled, single-cylinder, 4-stroke engine
Maximum Power	34 hp (25 kW) at 9, 500 rpm
Front Brake	300 mm disc, 4-piston caliper
Rear Brake	240 mm disc, single-piston caliper
Fuel Capacity	11.5 liters
Weight	169.5 kg (unladen weight, DIN)