Fuse assignment, ABS
OE
1 ABS (30 A)
2 Spare fuse (30 A)
3 Spare fuse (20 A)
4 ABS (20 A)
Installing ABS fuse
Remove the defective fuse and
replace it with a fuse of the
correct amperage rating.
Install the right side panel
( 94)
Bulbs
Notes
A defective bulb places
your safety at risk because
it is easier for other users to
oversee the motorcycle.
Replace defective bulbs as
soon as possible; always carry a
complete set of spare bulbs if
possible.
The bulb is pressurised and
can cause injury if dam-
aged.
Wear protective goggles and
gloves when changing bulbs.
The types of bulb fitted to
your motorcycle are listed
in the section entitled "Technical
data".
Do not touch the glass of
new bulbs with your fingers.
Use a clean, dry cloth to hold
the bulbs when handling them.
Dirt deposits, in particular oil and
grease, interfere with heat radi-
ation from the bulb. This leads
to overheating and shortens the
bulb's operating life.
Removing headlight
housing
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Remove screws 1 on left and
right.
Remove the left and right side
panels.
8
82
z
Maintenance
To Next Page
Loading...
Need help?
General
