Two-up
9 bar
Turn hose 2 counter-
clockwise to back it as far
as possible out of threaded
adapter 3.
The valve is now closed.
Disconnect threaded ad-
apter 3 from the valve, al-
lowing the pump to turn
with the adapter.
Screw the valve cap onto
the Air Damping System
valve.
Sit on the motorcycle, hold
it upright and allow as much
of your weight as possible
to rest on the motorcycle.
Push in the valve pin, allow
air to escape from the Air
Damping System and check
the level.
You can use the point of
the valve cap to push in
the valve pin.
Continue to allow air to es-
cape until the fore-and-aft
tilt indicator shows horizont-
al.
Installing the pneumatic
pump ( 45)
Damping
Telescopic-fork damping
You can fine-tune the
suspension to the road
surface by adjusting both
the compression-stage and
rebound-stage damping
characteristics of the
telescopic forks.
4
48
z
Operation
To Next Page
Loading...
Need help?
General
