BMW K1200GT User Manual

If ASC self-diagnosis did not
complete, the ASC warning
light continues to flash.
The ASC function is activ-
ated.
Instead of pressing the ASC
button, you have the option
of switching the ignition off
and then on again.
An ASC fault has
occurred if the ASC
warning light shows when the
motorcycle accelerates to a
speed in excess of 10 km/h
after the ignition was switched
off and then on again.
Front and rear seats
Removing rear seat
Make sure the ground is
level and firm and place the
motorcycle on its stand.
Turn key 1 counter-
clockwise in the seat
lock.
Lift the seat at the rear and
release the key.
with OE Seat heating:
Disconnect plug 2 by
squeezing locking tabs 3
together at top and
bottom.
Pull the seat to the rear to
release it from its holders.
Place the seat, upholstered
side down, on a clean sur-
face.
Remove the front seat
Removing rear seat ( 65)
4
65
z Operation

BMW K1200GT Specifications

General

Transmission	6-speed
Final Drive	Shaft
Front Brakes	Dual 320mm discs, 4-piston calipers
Engine Type	Liquid-cooled, 4-stroke in-line four-cylinder
Displacement	1157 cc
Power	152 hp @ 9500 rpm
Torque	130 Nm @ 7750 rpm
Seat Height	820/840 mm (32.3/33.1 in) (adjustable)
Dry Weight	249 kg
Weight (Wet)	approximately 282 kg
Front Suspension	BMW Duolever
Rear Suspension	BMW Paralever
Rear Brakes	2-piston caliper