fluid reservoir remains correctly
secured.
Remove mirror 3.
Using the tool from the on-
board toolkit, retighten nut 2.
Installing mirrors
Install mirror 3.
Use the tool from the on-board
toolkit to tighten nut 2.
Locknut (mirror) to
clamping piece
Joining compound: Multi-wax
spray
Locknut (mirror) to
clamping piece
20 Nm
Clip protective cap 1 into posi-
tion.
Removing and installing
number-plate carrier
Remove the number-plate
carrier
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Removing rear seat ( 61).
Remove the cable tie arrow
and disconnect plug 1 for the
number-plate carrier.
NOTICE
If the number-plate carrier is re-
moved in preparation for a race-
track session, the electronics
detect a bulb failure and the
appropriate warning appears
on the display. Activating the
EQIP WARN LAMP function in
the SETUP MENU suppresses
this warning.
5
86
z
On the race track
ProCarManuals.com
To Next Page
Loading...
Need help?
General
