Connect plug 1, hold it in po-
sition and secure the cable
tie arrow.
NOTICE
If the warning for bulb failure is
suppressed in preparation for a
race-track session, before the
motorcycle is ridden on public
roads the warning has to be
reactivated by selecting the
EQIP WARN LAMP function in
the SETUP MENU.
Install the rear seat ( 61).
Removing and installing
front turn indicators
Removing front flashing
turn indicator
NOTICE
The procedure described here
for the right side apply applies by
analogy to the left side panel.
Removing right cover ( 135).
Remove screw 1 and remove
the turn indicator. Work the
cable through the fairing side
panel.
Protect the plug on the motor-
cycle to prevent the ingress of
foreign matter.
Installing right cover ( 136).
Installing front flashing
turn indicator
Removing right cover ( 135).
Work the cable through the
fairing side panel.
Hold the flashing turn indicator
in position and install screw 1.
Installing right cover ( 136).
5
89
z
On the race track
ProCarManuals.com
To Next Page
Loading...
Need help?
General
