4 en | Safety Conettix Ethernet Communication Module
2016.08 | 08 | F.01U.266.226 Installation and Operation Guide Bosch Security Systems, Inc.
1 Safety
ESD Precaution
Please note that the B426 board comes without any case/box and all components are exposed
for finger touches - therefore extra attention must be paid to ESD (electrostatic discharge)
precaution. Make sure there is no static interference when using the board. Appropriate ESD
protections must be taken and wearing electrostatic equipment is recommended, such as anti-
static wrist strap.
ESD damage can range from subtle performance degradation to complete device failure.
Precision integrated circuits may be more susceptible to damage because very small
parametric changes could cause the device not to meet its published specifications.
Warning!
Failure to follow these instructions can result in a failure to initiate alarm conditions. Bosch
Security Systems, Inc. is not responsible for improperly installed, tested, or maintained
devices. Follow these instructions to avoid personal injury and damage to the equipment.
Notice!
Inform the operator and the local authority having jurisdiction (AHJ) before installing the
module in an existing system.
Disconnect all power to the control panel before installing the module.
Before installing a B426, refer to Technical specifications, page 33.
To Next Page
Loading...
Need help?
General
