English – 23
or the operating unit of the eBike, the eBike system, and therefore also the
battery, will switch off automatically to save energy.
This will place the Nyon (BUI350) into standby mode.
Standby mode
You can put your on-board computer in standby mode, which allows the on-
board computer and system to start up quicker when required.
The standby mode can be activated as follows:
– Press and hold the on/off button(3) of the on-board computer for 1 to
3seconds, making sure not to exceed 3 seconds.
– Wait for 10 minutes until the system switches off.
– Switch off the rechargeable battery via the on/off button of the battery.
Standby mode is ended if you press and hold the on/off button(3) of the on-
board computer for 1second.
Standby mode is ended and the on-board computer switches off automati-
cally if the state of charge of the on-board computer battery is less than
75%. In any event, the on-board computer will be switched off at the latest
when its internal clock reaches midnight (00:00).
IfNyon (BUI350) cannot be switched on or does not work properly, press
and hold the on/off button (approx. 15s). This could rectify the error.
Energy supply of the on-board computer
If the on-board computer is in the holder(4), a sufficiently charged eBike
battery is inserted into the eBike and the eBike system is switched on, then
the on-board computer battery is powered and charged by the eBike bat-
tery.
If the on-board computer is removed from the holder(4), the power is sup-
plied by the on-board computer battery. If the on-board computer battery's
charge is running low, a warning message appears on the display.
Color of the indicator Meaning
Green The on-board computer battery is
over 30% charged.
Orange The on-board computer battery is
charged between 15% and 30%.
Red The on-board computer battery is
less than 15% charged.
Bosch eBike Systems 1 270 U20 Nen | (02.10.2020)
To Next Page
Loading...
Need help?
General
