3. USING
CF
CARDS
3-3. Preparation
for
reading and writing data
1 With the power turned off, insert the
CF
card into the CF
slot.
Note:
• Make sure the CF card is facing the correct way.
• The cover should be closed at all times except when
0
m
.~
the CF card is inserted and removed, otherwise dust
~:.~,~,--
may cause trouble.
•
If
no valid data can be found, the CF media indicator
will not illuminate.
4453Q
2 Tum on the power switch.
3 Switching
to
CF
data read/write mode
While pressing the TEST
key,
press the
RNV
key.
• The mode number will
be
displayed
in
the PROGRAM
No. display and the setting will be displayed in the menu
display.
• The initial mode will be additional sewing data reading
mode. (Refer to the read/write mode
list.)
TEST
indicator and CF media indicator
li
ht 4574Q
4 Press the
11
or
V key to select the mode.
~
PROGRAM
No.
I
,-
,
[Read/write mode
list]
@
®
PROGRAM No.
Menu display
Setting items
display
r 1
[-SEd]
Additional sewing data is read from the CF card. *
w2
SEd- Additional sewing data is written to the CF card.
r3
-MEM Memory switch settings are read from the CF card.
w4
MEM- Memory switch settings are written to the CF card.
r5
[
-UPG]
User programs are read from the CF card.
w6
[
UPG-]
User programs are written to the CF card.
4575Q
r7
[
-SyS]
Control programs are read from the CF card and used to update the firmware
version.
w8
[LoG-
Error log data is written to the CF card.
*Additional sewing data that can be used by this product is data that has been created for the KE-4300/BE-4380.
KE·430D, BE·438D 19
To Next Page
Loading...
Need help?
General
