5. USING THE OPERATION PANEL (BASIC OPERATIONS)
40
KE-430F, BE-438F
5-3. Copying programs
To create a program with parameters that are almost exactly the same as those of another program, you can copy the original
program and change just the parts which need to be changed.
1
Select the program number to be used for creating
the new program.
Carry out steps 1 and 2 in “5-2. Program setting method”
to select the program number to be used for creating the
new program.
• Select a program number from 200 to 999.
2
Switch to program copy mode.
While pressing the F1 key (1), press the F4 key (2).
• “CoPy” will be displayed in the menu display, “PG”
will be displayed in the SECTION No. display, and the
number of the program containing the original data will
be displayed in the TENSION display.
• The displays will not appear in this way unless a
program number from 200 to 999 has been selected
as the new program number.
3
Select the program containing the original data.
Press the
or key (3) to change the number of
the program containing the original data.
• The value in the TENSION display will flash.
• If you press the RESET key, you can cancel the copy
operation and return to program mode.
4
Copy the program.
Press the ENTER key.
• All parameters in the program will be copied, and the
sewing machine will then return to the status in step 3
of “5-2. Program setting method”.
5
Change the necessary parameters.
Carry out the steps from step 4 onward in “5-2. Program
setting method” to change the necessary parameters.
2410B
For example, to create
program number 300:
2411B
2412B
2413B
2382B 2383B
2414B
For example, to copy
program number 12:
To Next Page
Loading...
Need help?
General
