7. SEWING
56KE-430F, BE-438F
7-2. Changing sewing conditions
“X-scale”, “Y-scale” and “Sewing speed” can be changed even during sewing standby.
The changes made at this time will be reflected in the program, so this is a useful way of changing programs while checking
actual sewing.
<Changing X-scale and Y-scale>
1. Press the SELECT key (1) so that the X-SCALE
indicator (2) (for X-scale setting) or the Y-SCALE
indicator (3) (for Y-scale setting) is illuminated.
・ The setting value (%) will be displayed in the menu
display (4).
2. Press the
or key (5) to set the scale (20 - 200).
・ The program number in the PROGRAM No. display
(6) will flash.
3. Depress the foot switch to the 2nd step.
・ The work clamp will move to the sewing start
position and the program number will change from
flashing to illuminated.
NOTE:
Once the setting is complete, be sure to carry out the
steps in "5-4./5-5. Checking the sewing pattern" to check
that the needle drop position is correct.
<Changing the sewing speed>
1. Press the SELECT key (1) so that the SPEED indicator
(2) is illuminated.
・ The setting value (sti/min) will be displayed in the
menu display (3).
2. Press the
or key (4) to set the sewing speed.
(Sewing speed values: KE-430F: 200 to 3200; BE-438F:
200 to 2700)
<Changing slow start pattern>
* This setting cannot be made when memory switch No.
100 is set to “OFF”.
1. While the SPEED indicator (1) is illuminated and the
sewing speed is being displayed in the menu display (2),
press the SELECT key (3).
• The setting value will be displayed in the menu display
(2).
2. Press the
or key (4) to set the slow start pattern.
* Refer to the list of parameters in “5-2. Program setting
method”.
2450B
2451B
2460B
To Next Page
Loading...
Need help?
General
