Bruker ultraflex Series User Manual

Bruker Daltonik GmbH 4 Cleaning the Source
Inspect the P2 plate carefully to make sure that all contamination has been removed. The
surface next to the center hole should be shiny.
Figure 4-16 Clean P2 plate
Discoloration can occur with a high-throughput workflow combined with source heating.
The source heating is unable to remove all contamination. Frequent manual cleaning is an
absolute necessity.
4.3 Final Tasks
Dry the parts inside the source using nitrogen to reduce pumping time (see Figure 4-17).
Excess fluid should be mopped up using a tissue before drying with nitrogen.
Figure 4-17 Drying the parts with
nitrogen
Figure 4-18 Blowing away the ethanol
ultraflex Series Cleaning Manual Revision 2 Page 37 of 44

Bruker ultraflex Series Specifications

General

Brand	Bruker
Model	ultraflex Series
Category	Measuring Instruments
Language	English