Bunn DUAL SH DBC User Manual

Page 18
PROGRAMMING FUNCTIONS (cont.)
SET NEW RECIPES (cont.)
Procedure for Setting the Recipe:
NOTE: Before beginning setup, place a server beneath
the left brew funnel.
1. Insert the funnel into the grinder and select a batch
size to grind. It is not necessary to have coffee beans
in the hopper(s) in order to program the brewer.
The coffee name is pre-selected and stored in the
grinder's memory for the side being ground.
2. Press the pad. When the grinder stops grinding,
remove the funnel.
3. On the brewer, press and hold the upper right
hidden switch until the display reads SET NEW
RECIPE. Release the switch.
4. Press and release YES. The display should read
INSERT FUNNEL WITH NEW NAME, then USE
LEFT SIDE ONLY, and fi nally, QUIT SETUP? These
three displays will repeatedly cycle.
5. Insert the funnel into the rails on the left side of
the brewer. The display should read the NAME of
the coffee that was ground into the funnel, along
with a NO and YES. If the NAME on the display is
correct, press YES.
6. If, for some reason, the name of the coffee from
the grinder did not load properly into the funnel,
or if a grind has not yet been done, the display will
read MUST GRIND INTO FUNNEL FIRST. It will be
necessary to grind another batch following steps
1 and 2.
7. If the grind is acknowledged by the brewer, the
display will read BEGIN SETUP OF (COFFEE
NAME). Then the screen will display BREW OZ.
and a batch light will be blinking. (Refer to page
22 for description of BREW OZ. function).
8. Using (-) and (+), set the amount of brew water, in
ounces, to be dispensed for that particular batch
size.
9. When fi nished, press another batch size and repeat
step #8 for that size. Continue setting all batch
sizes.
10. When fi nished setting all batch sizes, press and
release DONE. The display should read 3 BATCH
SIZES DONE?
ON TIME X:XX
(-) DONE (+)
OFF TIME X:XX
(-) DONE (+)
ON OFF
X:XX X:XX
DRIP TIME X:XX
(-) DONE (+)
3 BATCHES DONE?
NO YES
SET PREINFUSION?
NO YES
ADVANCES
TO NEXT
FUNCTION
5 SEC. DELAY
11. If the three batch sizes are not correct, press
and release NO to return to the BREW OUNCES
setup screen and repeat steps 8 through 10. If
the three batch sizes are correct, press YES. This
will advance to the % BYPASS function. (Refer to
page 24 for description of % BYPASS function.)
12. Using (-) and (+) set the amount of bypass water
(percentage) to be dispensed around the grounds
for that particular batch size.
13. When fi nished, press another batch size and repeat
step #12 for each batch to be set.
14. When fi nished setting each batch size, press
DONE. The display should read 3 BATCHES
DONE?
P2416
P2417
% BYPASS XX.X
(-) DONE (+)
3 BATCHES DONE?
NO YES
SET PULSE BREW?
NO YES
29877.2 121504

Bunn DUAL SH DBC Specifications

General

Brand	Bunn
Model	DUAL SH DBC
Category	Coffee Maker
Language	English