Page 11
PROGRAMMING THE BREWER (cont.)
PROGRAM FUNCTIONS - LEVEL 2
There are three methods of programming the
various brewing parameters of the SINGLE
®
SH with
Smart Funnel
®
Brewer.
METHOD 1:
Using a Smart Funnel
®
and a G92T DBC Grinder:
Certain coffee NAMES are stored in the G92T
DBC's memory. When a particular name of coffee is
ground into the Smart Funnel
®
, that name and the
batch size selected are transferred from the grinder to
the programming chip located in the funnel's handle.
The funnel is then inserted into the brewer's funnel
rails. The sensor coil on the brewer reads the informa-
tion contained in the handle. This then allows the
operator to set the BREW VOLUMES, BYPASS PER-
CENTAGES, PULSE BREW TIMES, PREINFUSION
TIMES and DRIP-OUT TIMES for that particular coffee
NAME. Each coffee NAME can be set individually to
provide optimum brewing quality.
METHOD 2:
Using a RECIPE CARD to enter all of the brew
settings at one time:
If using a coffee flavor not in the G92T DBC's
memory, the customer can obtain a RECIPE CARD
from the factory with all the information needed to set
up that particular coffee flavor. This includes the name
of the coffee, BREW VOLUMES, BYPASS PERCENT-
AGES, PULSE BREW TIMES, PREINFUSION TIMES,
and DRIP-OUT TIMES.
METHOD 3:
Not using a Smart Funnel
®
and/or a G92T DBC
Grinder:
This allows the operator to enter ONE set of
brewing parameters in the event a Smart Funnel
®
and/
or a G92T DBC is not used with the SINGLE
®
SH
Brewer. This is referred to as a NO NAME coffee flavor.
If the brewer does not read the information in the
funnel handle, it automatically selects the NO NAME
brewing parameters set up prior to brewing. This
includes the BREW VOLUMES, BYPASS PERCENT-
AGES, PULSE BREW TIMES, PREINFUSION TIMES
and DRIP-OUT TIMES for the three batch sizes.
RECIPES
This diagram allows for the creating, modifying, or
viewing of recipes in the brewer.
P2438
34025 022403
To Next Page
Loading...
Need help?
General
