Page 16
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
SET NEW RECIPE:
If not using a Smart Funnel
®
(with a sensor coil) and/
or a G92T DBC Grinder, the brewer will function as
a standard BUNN
®
Single
®
Brewer:
It is possible to operate the brewer without using
a Smart Funnel
®
and/or a G92T DBC Grinder. If a
standard funnel, or if a non-DBC grinder is used the
brewer will automatically select a NO NAME coffee
flavor when the pad is pressed. This means that
no name was read from the funnel's handle.
There is a NO NAME coffee program that can be set
in the brewer. This includes BREW VOLUMES, BY-
PASS PERCENTAGES, PULSE BREW TIMES,
PREINFUSION TIMES and DRIP-OUT TIMES. The
brewer will perform in the same capacity as a standard
BUNN Single
TM
Brewer.
The instructions for programming the NO NAME
settings are on the following pages. The same steps
are followed for setting the recipe as those that are
used to MODIFY A RECIPE, beginning on page 18.
Note that when the display reads NO NAME, that is
when MODIFY should be pressed in order to set the
parameters for the NO NAME coffee.
NOTE: Before beginning setup, insert a funnel into the
funnel rails, and place a Soft Heat
®
Server beneath the
brew funnel.
P2441
34025 022403
To Next Page
Loading...
Need help?
General
