Bunn SINGLE SH DBC Operating Manual

Page 13
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
SET NEW RECIPES (cont.)
8. Using (-) and (+), set the amount of brew water, in
ounces, to be dispensed over the grounds for that
particular batch size.
9. When finished, press another batch size and re-
peat step #8 for that size. Continue setting all batch
sizes.
10. When finished setting all batch sizes, press and
release DONE. The display should read 3 BATCH
SIZES DONE?
11. If the three batch sizes are not correct, press and
release NO to return to the BREW OUNCES setup
screen and repeat steps 8 through 10. If the three
batch sizes are correct, press YES. This will ad-
vance to the % BYPASS function. (Refer to page
19 for description of % BYPASS function.)
12. Using (-) and (+) set the amount of bypass water
(percentage) to be dispensed around the grounds
for that particular batch size.
13. When finished, press another batch size and re-
peat step #12 for each batch to be set.
14. When finished setting each batch size, press DONE.
The display should read 3 BATCHES DONE?
15. If the three batch sizes are not correct, press and
release NO to return to the % BYPASS setup
screen and repeat steps 12 through 15. If they are
correct, press YES. This will advance to SET PULSE
BREW. (Refer to page 20 for description of SET
PULSE BREW function.
16. To SET PULSE BREW, if setting pulse brew BY
EXAMPLE (brewing into a funnel) press YES and
proceed with the setup instructions for SETTING
PULSE BREW - BY EXAMPLE, on page 22.
17. If setting pulse brew by ENTER TIMES (entering
known times) press NO. The display should read
ENTER TIMES. Press and release YES and pro-
ceed with the setup instructions for SETTING
PULSE BREW - ENTER TIMES, page 23. After SET
PULSE BREW has been accomplished, the next
function will be SET PREINFUSION. (Refer to page
24 for description of SET PREINFUSION function.
18. To SET PREINFUSION press YES in the SET
PREINFUSION screen to proceed. The display
should now read ON TIME and a batch light will be
blinking.
19. Using (-) and (+), set the amount of time the brew
water will initially presoak the grounds for that
particular batch size.
20. When finished, press another batch size and re-
peat until all three batch sizes are set.
21. When finished, press DONE. The display should
now read OFF TIME and a batch light will be
blinking.
P2416
P2417
34025 100501

Bunn SINGLE SH DBC Specifications

General

Brand	Bunn
Model	SINGLE SH DBC
Category	Coffee Maker
Language	English