2.0 11/2012 © CAME cancelli automatici s.p.a.
The data and information reported in this installation manual are susceptible to change at any time and without obligation to notify users.
EN
Installation
Preliminary checks
⚠Before proceeding with the installation, it is necessary
to
:
• Make sure that the point where the electrical panel is
anchored is free from any impacts, and that the surface
is solid and that proper tools and materials are used (i.e.
screws, wall plugs, etc.).
• Set up a suitable omnipolar cut-off device, with distances
greater than 3 mm between contacts, with sectioned
power source.
•
Check that any connections inside the container
(made for continuity purposes of the protective circuit)
are fitted with extra insulation compared to other internal
conductive parts.
• Set up proper conduits and electric cable raceways,
making sure these are protected from any mechanical
damage.
Equipment and materials
Make sure all the necessary tools and materials are avai-
lable to carry out the installation with the maximum safe-
ty, in compliance with regulations in force. Here are some
examples:
To Next Page
Loading...
Need help?
General
