30
Choose either or by pressing the COMPUTER 1 or
COMPUTER 2 button on the remote control unit.
Before using these buttons, correct input source should be selected through Menu operation as described below.
1
2
3
When the Auto input function is set to On 1
or On 2 in the Auto setup function, the input
signal will be searched automatically (p.52).
COMPUTER 1
Press the MENU button to display the On-Screen
Menu. Use the Point ▲▼ buttons to select
and then press the Point ► or the OK button.
Use the Point ▲▼ buttons to select COMPUTER 1.
When COMPUTER 1 is selected, press the Point
► button to access the submenu items. Use the
Point ▲▼ buttons to select the
input source and then press the OK button.
Direct Operation
Menu Operation
OR
Use the Point ▲▼ buttons to select COMPUTER 2
and then press the OK button.
To Next Page
Loading...
Need help?
General
