141
Admin Viewer/VB Viewer
5
The operations and settings that can be performed only in the Admin Viewer are explained.
Using Control for Admin
When you have obtained control privileges, click the
[Control for Admin] button to display the Control for Admin
Panel and perform camera operation and video settings.
Opening/Closing and Moving Control Items
Clicking the title of a control item will open or close it.
You can open the various control items even without
obtaining the camera control privileges, but all items other
than [Video Reception] are not available.
You can also reorder control items using the up/down
buttons.
Performing Operations and Settings
Click the camera control buttons to set the pan, tilt and
zoom operations as well as the speed.
(1) [Pan/Tilt] button
Move pan and tilt in the direction of the arrows.
Operation will continue as long as you are holding
down the button and will stop when you release it.
Click the center button to center the camera at 0° pan,
45° tilt (When upright. -45° when ceiling mounted).
(2) [Pan/Tilt Speed] button
Select a pan/tilt speed from [Fast], [Normal] and
[Slow].
(3) [Control speed by zoom position] checkbox
Check the box to adjust the pan/tilt speed in response
to the visible range. Pan/tilt speed is slowest at
maximum telephoto, and fastest at maximum wide
angle. Uncheck the box to pan/tilt at a set speed.
The checkbox is always checked if [Control by zoom
position] is selected in [Camera] > [Camera Control]
> [Pan/Tilt Speed Control] on the setting page (p. 49).
The pan/tilt speed control can be enabled/disabled
using this checkbox when [Control at set speed] is
selected in [Camera] > [Camera Control] > [Pan/Tilt
Speed Control].
(4) [Zoom] button
Zooms in or out. Operation will continue as long as
you are holding down the button and will stop when
you release it.
(5) [Zoom Speed] button
Set the zoom speed to [Fast] or [Slow].
Note
Changing the [Pan/Tilt Speed] or [Zoom Speed] will not change
the speed of the slider, or of the pan, tilt or zoom in panorama.
Performing Operations and Settings in the Admin Viewer
⇔
⇔
(1)
(4)
(2)
(5)
(3)
To Next Page
Loading...
Need help?
General
