15
INTERNATIONAL CHILLER VISUAL CONTROLLER
(ICVC) — The ICVC is the “brain” of the PIC III system. This
module contains all the operating software needed to control
the chiller. The ICVC is mounted to the control panel (Fig. 10)
and is the input center for all local chiller set points, schedules,
configurable functions, and options. The ICVC has a stop
button, an alarm light, four buttons for logic inputs, and a
backlight display. The backlight will automatically turn off
after 15 minutes of non-use. The functions of the four buttons
or “softkeys” are menu driven and are shown on the display
directly above the softkeys.
The viewing angle of the ICVC can be adjusted for opti-
mum viewing. Remove the 2 bolts connecting the control panel
to the brackets attached to the cooler. Place them in one of the
holes to pivot the control panel forward to backward to change
the viewing angle. To change the contrast of the display, access
the adjustment on the back of the ICVC. See Fig. 10.
The ICVC features 4 factory programmed languages:
English (default)
Chinese
Japanese
Korean
NOTE: Pressing any one of the four softkey buttons will acti-
vate the backlight display without implementing a softkey
function.
The ICVC may be identified by viewing the back of the plate
on which the display is mounted. (Open the control panel door
to view.) Note any of the following distinguishing features in
Table 2.
Table 2 — Identification Features of the ICVC
CONTROLLER
COLOR
OF
PLATE
CEPL No.
(hardware)
SOFTWARE
OTHER
MARKINGS
ICVC Metallic
CEPL
130445-02
CESR
131350-0X
“PIC III”
Marking
on back
of green
circuit
board
OIL COOLER THERMOSTATIC
EXPANSION VALVE (TXV)
OIL COOLER THERMOSTATIC
EXPANSION VALVE (TXV) BULB
OIL HEATER TERMINAL
BOX
HIGH PRESSURE
SWITCH LOCATION
COMPRESSOR DISCHARGE
TEMPERATURE SENSOR
CABLE
GUIDE VALVE
ACTUATOR CABLE
DIFFUSER PRESSURE
AND DIFFUSER ACTUATOR
CABLE (FRAME 4 & 5
COMPRESSOR ONLY)
OIL RECLAIM
SIGHT GLASS
CABLE FROM
CONTROL PANEL
COMPRESSOR OIL SUMP
TEMPERATURE CABLE
COMPRESSOR OIL SUMP
PRESSURE CABLE
BEARING TEMPERATURE
SENSOR CABLE
COMPRESSOR OIL DISCHARGE
PRESSURE CABLE
MOTOR TEMPERATURE
SENSOR CABLE
Fig. 9 — 19XRV Compressor Controls and Sensor Locations
a19-1606