EasyManuals Logo

Carrier AquaForce 30XQ0502 User Manual

Carrier AquaForce 30XQ0502
49 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
46 Carrier Yileng - Shanghai, China
11 START-UP CHECK LIST FOR 30XQ HEAT PUMP CHILLERS (USE FOR JOB FILE)
Preliminary information
Job name:..................................................................................................................................................................
Location:......................................................................................................................................................................
Installing contractor:....................................................................................................................................................
Distributor:....................................................................................................................................................................
Unit
Model:.............................................................................................
Compressors
Circuit A Circuit B
Model number............................................. ............. Model number.................................................................
Serial number........................................................... Serial number........................................................... ........
Motor number........................................................... Motor number........................................................... .........
Circuit C Circuit D
Model number............................................. ............. Model number................................................................
Serial number........................................................... Serial number........................................................... ........
Motor number........................................................... Motor number........................................................... .........
Evaporator
Model number................................................................................
Serial number.................................................................................
Condenser
Model number................................................................................
Additional optional units and accessories...................................................................................................................
.......................................................................................................................................................................................
Preliminary equipment check
Is there any shipping damage? ........................................If so, where?.....................................................................
......................................................................................................................................................................................
Will this damage prevent unit start-up?........................................................................................................................
Unit is level in its installation
Power supply agrees with the unit nameplate
Electrical circuit wiring has been sized and installed properly
Unit ground wire has been connected
Electrical circuit protection has been sized and installed properly
All terminals are tight
All chilled water valves are open
All chilled water piping is connected properly
All air has been vented from the chilled water circuit
Chilled water pump (CWP) is operating with the correct rotation. Check the phase sequence of the electrical connection.
After the pump test has been completed, switch the unit off again
Circulate chilled water in the water circuit for at least two hours, then remove, clean and replace the screen filter.
After the pump test has been completed, switch the unit off again.
Inlet piping to cooler includes a 20 mesh strainer with a mesh size of 1.2 mm.
condenser/ cooling Water quality should meet with Carrier requirements about heat exchanger water quality.
The compressor flange has been removed.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Carrier AquaForce 30XQ0502 and is the answer not in the manual?

Carrier AquaForce 30XQ0502 Specifications

General IconGeneral
BrandCarrier
ModelAquaForce 30XQ0502
CategoryChiller
LanguageEnglish

Related product manuals