Cascade H Series User Manual

INSTALLATION
7
6095756-R2 EN
9
10
Locate the auxiliary valve lever that operates the
hydraulic hoses connected to the solenoid control
valve P and T ports. Install a new knob with
pushbutton, or shrink-wrap low profile switch onto
the control lever.
IMPORTANT: Lever should control the ROTATE
function per ANSI (ISO) standard. When the
pushbutton is depressed, the lever should activate
the SWING function.
CAUTION: Secure cable with cable ties to avoid
pinching at truck cowl during handle movement.
Connect the wiring from the pushbutton and
control valve terminals to the truck electrical
system as shown.
IMPORTANT: Fuse must be connected to an
unswitched positive terminal – control valve must
be able to energize with truck key in off position.
AC0234.eps
AC0402.eps
LOW PROFILE SWITCH ON CONTROL LEVER
SOLENOID KNOB WITH PUSHBUTTON
Pushbutton switch
shrink-wrapped to
control lever
Cable Ties
Foam Tape
Heat-Shrink Tubing
ROTATE Control Lever
75 mm typical
NOTE: Remove
tubing around
button as desired
New knob with pushbutton
(ROTATE Control Lever)
Cable Ties
RC0736.eps
7.5 Amp Fuse
7.5 Amp Fuse
Pushbutton
White
Black
Diode
Coil
Control Knob
with Pushbutton
Solenoid Coil
Control Valve
Truck
Power
Source
(unswitched)
Diode
IMPORTANT: Banded
end must connect to
positive (+) side of
circuit
Cable
OR
Low profile
switch wrapped
to control lever

Cascade H Series Specifications

General

Brand	Cascade
Model	H Series
Category	Power Tool
Language	English